Fronius TransSteel 2200, Руководство по эксплуатации

Страница: 68 / 136

MIG/MAG Standard Manual Welding
General The MIG/MAG standard manual welding process is a MIG/MAG welding process with no
synergic function.
Changing one parameter does not result in any automatic adjustments to the other para-
meters – all variable parameters must be adjusted individually.
Adjustable weld-
ing parameters: The following parameters are available for MIG/MAG manual welding:
Wire speed
Welding voltage
Arc-force dynamic - for influencing the short-circuiting dynamic at the instant of
droplet transfer
MIG/MAG stand-
ard manual weld-
ing
1
Press the "Process" button to select MANUAL
2
Press the "Mode" button
to select the desired MIG/MAG mode:
2-step mode
4-step mode
Spot welding/stitch welding
3
Select and set the wire speed parameter
4
Select and set the welding voltage parameter
All parameter set values remain stored until the next time they are changed. This applies
even if the power source is switched off and on again.
5
Ensure that the ground earth connection has been established
6
Ensure that the shielding gas supply has been established
-
Power source is ready for welding
Corrections dur-
ing welding The arc-force dynamic parameter can be used to optimize the welding result.
The arc-force dynamic parameter is used to influence the short-circuiting dynamic at the
moment of droplet transfer:
- = hard, stable arc
0 = neutral arc
+ = soft, low-spatter arc
68