Fronius Robacta TSS /i, Руководство по эксплуатации, Страница: 9 / 100

Install the device at a minimum distance of 1 m (40 in.) away from IT equipment and con-
trol lines, as well as from the welding process.
Set up the device in such a way that welding spatter cannot hit the cleaning device.
Before transporting the device, always completely drain the parting agent.
Take care to ensure that the applicable national and regional guidelines and accident
prevention regulations are observed when transporting the device, especially guidelines
concerning hazards during transport and shipment.
It is essential to conduct a visual inspection of the device to check for damage after it has
been transported but before it is commissioned. Have any damage repaired by trained
service technicians before commissioning the device.
Safety Measures
in Normal Opera-
tion Only operate the device when all safety devices are fully functional. If the safety devices
are not fully functional, there is a danger of:
-
Injury or death to the operator or a third party
- Damage to the device and other material assets belonging to the operating company
- Inefficient operation of the device
Safety devices that are not fully functional must be repaired before the device is started
up.
Never bypass or disable safety devices.
Before starting up the device, ensure that no one can be put in danger.
The device must be examined at least once a week for externally detectable damage
and functionality of the safety devices.
- Only use appropriate original parting agents from the manufacturer.
- When handling parting agents, observe the information on the parting agent safety
data sheets. The parting agent safety data sheets can be obtained from your service
center or via the manufacturer’s website.
- Do not mix parting agents from the manufacturer with other parting agents.
- If damage occurs due to the use of other parting agents, the manufacture is not
liable for this and all warranty claims are forfeited.
- Properly dispose of used parting agents according to national and international regu-
lations.
Maintenance and
repair It is impossible to guarantee that bought-in parts are designed and manufactured to meet
the demands made of them, or that they satisfy safety requirements.
-
Use only original spare and wearing parts (also applies to standard parts).
- Do not carry out any modifications, alterations, etc. to the device without the manu-
facturer's consent.
- Components that are not in perfect condition must be replaced immediately.
- When ordering, please give the exact designation and part number as shown in the
spare parts list, as well as the serial number of your device.
The housing screws provide the ground conductor connection for earthing the housing
parts.
Only use original housing screws in the correct number and tightened to the specified
torque.
Safety Inspection The manufacturer recommends that a safety inspection of the device be performed at
least every 12 months.
9
EN-US