Fronius Robacta Reamer V 70 Han12P, Руководство по эксплуатации, Страница: 57 / 76

Care, maintenance and disposal
General The cleaning device generally needs no maintenance. However, to keep the cleaning
device in good working condition for years to come, several points on care and mainten-
ance must be observed.
Before each start-
up - Check fill level in parting agent container and top up if necessary
- Check fill level in parting agent spatter tray and empty if necessary
- Check cleaning cutter for wear and replace if necessary
- Empty the cleaning device spatter tray
- If fitted, empty the wire cutter tray
- Carry out a general visual inspection of the cleaning device and make sure that any
damage is repaired immediately (before start-up)
Daily
CAUTION!
Danger from cleaning agents containing solvents.
This can result in damage to property.
▶
Only use solvent-free cleaning products on the cleaning device.
1
Remove parting agent deposits and dirt from device
Weekly
CAUTION!
Danger from cleaning agents containing solvents.
This can result in damage to property.
▶
Only use solvent-free cleaning products on the parting agent container.
1
Check the parting agent container for soiling and clean if necessary
2
Blow through suction filter in parting agent container using compressed air from the
inside outwards through the suction hose (for more detailed information see section
Starting up the parting agent nebuliser from page 41 )
Every 6 months
1
Open the device and check the pneumatic valves for
-
Leaks
- The secure seating of all screws
- The secure seating of all screw joints on the pneumatic valves
As necessary Open the device and
1
Clean inside of device using dry reduced compressed air
2
Lightly oil the lifting device cylinder guides
3
Restore the original condition of the device
57
EN