Fronius MagicWave 1700 Job, Руководство по эксплуатации

Страница: 89 / 148

89
EN
Job correction
General In the Job correction menu, setup parameters can be adapted to the specific requirements
of individual jobs.
Opening the Job
correction menu
Changing weld -
ing parameters
Exiting the Job
correction menu
Welding parame -
ters that can be
corrected in the
Job correction
menu
NOTE!
Certain welding parameters apply specifically to the Job correction menu and relate,
for example, to altering settings that were made on the control panel the first time
the job was stored.
There is an explanation of each of these welding parameters in the following list, together
with information about the setting ranges.
You can alter the following welding parameters for any stored job:
Using the Mode button, select "Job mode".
Press and hold the Store button
Press the Mode button
The power source is now in the Job correction menu. The first welding pa
-
rameter, "Job", is shown. The "Job" parameter is used to select the job for
which the welding parameters are to be adjusted.
1
2
3
Turn the adjusting dial to select the job whose welding parameters you
want to change
Use the left or right parameter selection button to select the welding pa
-
rameter that you want to correct
Use the adjusting dial to change the welding parameter value
IMPORTANT! Any welding parameters that you change will be stored im -
mediately and accepted as the valid parameters for the welding process.
1
2
3
Press the Store button
1
Eld
Electrode Diameter
Unit mm in.
Setting range OFF - max. OFF - max.
Factory setting 2,4 0.095