NOTE!
Observe the following points for smooth cleaning operation:
▶
Press the hand pump every 2 to 3 seconds to deliver cleaning electrolyte.
More cleaning electrolyte is required with a higher cleaning power, because the
cleaning electrode and workpiece become hotter and the cleaning electrolyte evap-
orates more quickly.
▶
When cleaning with the cleaning felt, apply slight pressure to the weld.
▶
If the operating noise ("crackling") is increased, insufficient cleaning electrolyte is be-
ing used; it is better to clean in a puddle than too dry.
▶
Always hold the cleaning brush perpendicular to the weld, and always moistened
with cleaning electrolyte.
Apply light pressure to the area to be cleaned.
▶
When cleaning with the cleaning brush, sparking, foaming, and increased operating
noise may occur - this is normal.
After cleaning
1
1
2
Place cleaning electrode | cleaning brush ...
in the cleaning torch holder
1
1
2
3
Switching off the device
36
