Fronius KD Supply 2500, Руководство по эксплуатации

Страница: 8 / 16

Fitting the KD Supply 2500 to the trolley
General remarks The welding system can be fitted to a trolley to increase the mobility of the system.
IMPORTANT!
If the welding system is not equipped with an auto-transformer or a cooling unit,
the KD Supply 2500 must be installed right at the bottom.
- If a cooling unit is present, fit it right at the bottom and place the KD Supply on top of
it.
Fitting the KD
Supply 2500 to
the base of the
trolley
1
If there are no fastening brackets on
the trolley:
Attach two fastening brackets to the
base of the trolley and secure each
one using three „Extrude-Tite“ screws.
2
Place the KD Supply 2500 on the
base of the trolley.
3
Using „Extrude-Tite“ screws, fasten
the KD Supply 2500 at the front and
back to the fastening brackets on the
base of the trolley.
8