37
EN
Care, maintenance and disposal
General
The device generally needs no maintenance. However, to keep the device in good working
condition for years to come, several points on care and maintenance must be observed.
Example: con
-
sumption of filler
metal
Sample calculation, consumption of steel filler metal:
Vd. speed = 12 m/min (filler metal 1.2 + 1.0) = 10.8 kg/h deposition rate -> rounded to 10
kg/h
At 50 hours of arc time:
10 kg/h x 50 h = 500 kg filler metal = 2 wire drums of 250 kg each
Before shift
starts/before
starting up
-
Check the welding torch wearing parts:
-
Gas nozzle
-
Contact tip
-
Gas distributor
-
Spatter guard...
After 25 hours of
arc time
-
Gas purge the inner liners
After 50 hours of
arc time
-
Gas purge the Robacta Drive EasyTwin drive unit
-
Check the feed rollers
If the feed rollers are worn, the axle block of the pressure rollers and the counter bearing
of the double roller must be replaced (see "Replacing wearing parts").
Disposal
Dispose of in accordance with applicable national and local regulations.
Содержание Drive EasyTwin
