30
Control elements and connections
Drive EasyTwin
drive unit con
-
trols
NOTE!
Do not allow long lengths of wire electrode to be retracted, as the wire electrode is
not automatically wound up when retracted.
(3)
(1)
(2)
No.
Function
(1)
Gas-test button
for setting the required gas flow rate on the pressure regulator
(2)
Wire threading button
to thread the wire electrode into the torch hosepack with no accompanying flow
of gas or current
Thread the wire electrode using the preset feeder inching speed:
No.
Function
(3)
Wire retract button
The wire retract button only works with the PowerLiner variant.
Retraction of wire electrode without accompanying flow of gas or current
Retract the wire electrode using the preset wire retract speed
Содержание Drive EasyTwin
