Fronius AccuPocket 150/400 TIG, Руководство по эксплуатации

Страница: 22 / 88

After installation, an accessible mains plug is required.
EMC measures In certain cases, even though a device complies with the standard limit values for
emissions, it may affect the application area for which it was designed (e.g. when
there is sensitive equipment at the same location, or if the site where the device
is installed is close to either radio or television receivers).
If this is the case, then the operating company is obliged to take appropriate ac-
tion to rectify the situation.
Maintenance Before switching on, always check the mains plug and cable as well as charger
leads and charging terminals for any signs of damage.
If the surface of the device housing is dirty, clean with a soft cloth and solvent-
free cleaning agent only.
Maintenance and
repair Maintenance and repair work must only be carried out by authorised personnel.
Use only original spare and wearing parts (also applies to standard parts). It is
impossible to guarantee that bought-in parts are designed and manufactured to
meet the demands made on them, or that they satisfy safety requirements.
Modifications, installations or conversions are only permitted with the approval
of the manufacturer.
Warranty and li-
ability The warranty period for the charger is 2 years from the date of invoice.
However, the manufacturer will not accept any liability if the damage was caused
by one or more of the following:
- Use of the charger "not in accordance with the intended purpose"
- Improper installation and operation.
- Operating the charger with faulty protection devices.
- Non-compliance with the operating instructions.
- Unauthorised modifications to the charger.
- Catastrophes caused by the activities of third parties and force majeure.
Safety inspec-
tion The manufacturer recommends that a safety inspection of the device is per-
formed at least once every 12 months.
The safety inspection may only be performed by an appropriately qualified elec-
trician
- After any changes have been made
- After any additional parts are installed, or after any conversions
- After repair, care and maintenance are carried out
- At least every twelve months
For safety inspections, follow the appropriate national and international stand-
ards and directives.
Further details on safety inspections can be obtained from your service centre.
They will provide you on request with any documents you may require.
22