Step 2: Set the Cartridges
2.
Set the FROG @ease Mineral
Cartridge to #7 using the dial on
the bottom of the cartridge. No
further adjustments are necessary
for the life of the cartridge.
1.
Remove the FROG @ease SmartChlor Cartridge from its
bag before proceeding.
Jacuzzi
®
Spa Gallons
Setting #
200-350
4
350-450
5
450-600
6
3.
Set the FROG @ease SmartChlor Cartridge to the setting
that matches your hot tub size in gallons. If needed, you may
increase or decrease the dial setting.
Once set, the FROG @ease SmartChlor Cartridge will maintain
a low 0.5 to 1.0 ppm chlorine level as long as the pH stays
within 7.2 and 7.8 so typically there is little need to adjust the
cartridge setting.
The combination provides the Fresh Mineral Water
®
benefits o
f
cleaner,
clearer and softer water
that’s easier to take care of
.
The FROG
@ease System
has two
replaceable
cartridges.
FROG
®
@
ease
®
is a hot tub sanitizing system
+
custom
designed for Jacuzzi
®
Hot Tubs that takes the guess
work out of water care so you always feel at ease
while enjoying your hot tub.
DIRECTIONS FOR USE: For use in hot tubs up to 600 gallons. Use with the
FROG @ease SmartChlor Cartridge in the FROG @ease Sanitizing System
for Jacuzzi
®
Hot Tubs. Ensure all hot tub equipment is working properly.
Operate the pump and filter as recommended by your hot tub manufac-
turer. Clean filter following manufacturer’s directions. May be used with a
previously filled hot tub unless it was sanitized with bromine or biguanides.
Then drain and fill the hot tub with fresh water before using this product.
Active Ingredient:
Silver Chloride ................................... 0.5%
Other Ingredients: ............................. 99.5%
Total:
................................................100.0%
FROG
@
ease Mineral Cartridge
Sanitizing System
Operating
Instructions
for JACUZZI
®
HOT TUBS
Read entire operating instructions for
complete directions for use.
Step 1: Prepare the Hot Tub
1.
2.
3.
Fill hot tub with fresh water. If using source water that is high
in calcium, iron or other metals, see your dealer before filling
the hot tub. It may require the use of a metal control product.
Clean or replace filter cartridges
when dirty (Follow manufacturer’s
instructions).
IMPORTANT:
Always follow printed instructions on the balancing
chemical packages. Add balancing chemicals in small increments one at a
time with the jets on and wait 6 hours before testing again and adding any
additional balancing chemicals.
Balance water by following STEPS a - d in order.
If previously using bromine
and switching to FROG @ease System,
you must drain and refill your hot tub before using this product.
If previously using dichlor
you may convert to FROG @ease System
without having to drain the hot tub, as long as cyanuric acid level is
below 80 ppm.
Very Important!
After balancing and
before using cartridges, establish an initial
residual of 0.5 - 1.0 ppm free chlorine with
FROG
®
Jump Start
®
start-up shock, includ-
ed in this package, that quickly dissolves
with an effervescent fizzing action – one
packet per 600 gallons.
Heat water to the manufacturer’s recommended
temperature.
4.
5.
b.
Look at the
Total Alkalinity
reading first. Adjustments
should be made to bring the Total Alkalinity in the
range of
80 – 120 ppm
prior to making any adjustments to pH even if
it throws pH off further.
a.
Take a water sample from the hot tub
and dip a FROG @ease Test Strip into it.
c.
After Total Alkalinity is in range,
test for pH
. It should be
between 7.2 and 7.8.
If higher or lower, add a pH adjuster.
d.
Lastly
test for Hardness.
It should be
between 150 and
250 ppm
. If higher, partially drain the hot tub (about 6 inches)
and fill with water low in calcium. If lower, add Calcium Increaser.
If balancing takes longer than 2 days shock the water and
maintain a chlorine level while continuing balancing.
Open the arms of the holder until they
snap into position. The handle with the
Jacuzzi
®
logo is the top of the holder.
1.
Step 3: Put the System to Work
If the FROG @ease Holder is
already installed, remove by pulling
up and away from filter cartridge
using the handle at the top of the
holder.
3.
2.
Remove the filter cover.
arm
Blue -
FROG @ease
Mineral Cartridge
Silver
- FROG @ease
SmartChlor
®
Cartridge
KEEP OUT OF REACH OF CHILDREN CAUTION
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling.
1
2
3
Ver la versión en español de este manual en frogproducts.com
Water Balance Guidelines
pH:
7.2 – 7.8
Total Alkalinity:
80 - 120 ppm
Hardness:
150 - 250 ppm
Total Dissolved Solids: <1500
Cyanuric Acid:
0 - 50 ppm
