Fritsch PULVERISETTE 6 Classic, Руководство по эксплуатации, Страница: 15 / 70

1. Insert the included triangular key (A) into the bore hole on the
bottom side of the PULVERISETTE 6 classic line and turn it clock-
wise 180 degrees.
2. Unlock the latch (2) by pressing the hood handle (1).
3. The hood (3) can now be opened.
4. The mill can only be switched on again if the hood (3) is closed and
the safety lock (7) has been reactivated by turning the triangular
key 180 degrees anticlockwise.
2.6.2 Imbalance switch
The device switches off if there is excessive imbalance. If this is the case,
then the counterweight has to be readjusted.
CAUTION!
The imbalance switch can be disabled at your own risk.
The Fritsch company will give no guarantee for damage
resulting from disabling of the imbalance switch!
NOTICE!
Change these settings only after all work as described in
Ä
Chapter 4 ‘Installation’ on page 20 has been carried
out!
In the default setting of the imbalance switch, it is acti‐
vated!
Activation / deactivation of the imbalance switch in Setup mode:
1.
Press and hold the STOP button on the front control panel.
Safety information and use
- 15 -