5.
Open SOP management and insert a new SOP. Insert the command
‘Rinse’ .
6.
Then press the button with the triangle on the right side of the
command to execute the command.
Make sure that the water connection or the
storage container is open.
5.3.4 Sample addition
1.
Start the desired SOP in the "ISS" program. (see Chapter
Chapter 5.5 ‘Fritsch test powder F70’ on page 41)
2.
You can add sample material as follows:
n
Add suspensions in small doses to the sample bath using a pip-
ette until the beam absorption set in the SOP is reached.
n
Solids can be put directly into the sample bath using a small
spatula, until the beam absorption set in the SOP is reached.
3.
Start the measurement once the parameters defined in the SOP
have been reached.
Using the device
- 39 -
Содержание ANALYSETTE 28 IMAGESIZER
Страница 6: ...14 Index 63 Table of contents 6 ...
Страница 61: ...13 Safety logbook Date Maintenance Repair Name Signature Safety logbook 61 ...
Страница 62: ...Date Maintenance Repair Name Signature Safety logbook 62 ...
Страница 65: ......
