2
1.
Introduction
This product is compatible with Nikon F mount and Fujifilm G mount protocols. It can control lens’
aperture electronically, auto focus and report lens information for EXIF recording.
There is a built
-
in aperture motor so that it can drive aperture diaphragm of not only E lenses, but
also AF, D and G lenses. In addition to that, the adapter supports more unique features including Phase
Detection AF (on GFX100 & GFX100S only, so far), IBIS, Lens VR, In
-
camera LaCA (Lateral Chromatic
Aberration) Correction, and In
-
camera vignetting and distortion correction, etc.
2.
Compatibility
This adapter works on G mount cameras. On cameras without PDAF support, such as GFX50s,
GFX50r and GFX50s II, adapted lenses can only work in the CDAF mode. Most of lenses on the tested
and optimized lens list should work normally in the AF
-
S mode. However, as many F mount lenses are
not designed for contrast AF, AF speed may be slow. And AF accuracy may not be good, either.
Meanwhile, AF
-
C mode is not supported. If AF performance can’t satisfy you, MF is recommended.
On cameras with PDAF support, such as GFX100 and GFX100S, tested and optimized lenses AF
much faster and more accurate. In some circumstances, the experience of using adapted lenses on
these cameras is just like using a DSLR. Thus, if you are about to purchase a new G mount camera to
use F mount lenses, the 102M pixel models are highly recommended.
This adapter works with F mount lenses. It supports electronic aperture control on Nikon AF, D, G,
and E lenses and other electronic F lenses from third parties like Sigma and Tamron. There is an
aperture motor inside the adapter. Thus, lenses with mechanical diaphragm controls as well as
G mount
including a dust proof rubber ring
F mount
Lens release
Micro USB port
for firmware update
