TO BE REMOVED BY THE CUSTOMER AFTER INSTALLATION IS COMPLETE.
INSTALLATION CHECKOFF LIST
Doors
Handles are secure and tight
Door seals completely to cabinet on all sides
Doors are level across the top
Leveling
Refrigerator is level, side to side and tilted 1/4” (6mm) front to back
Toe grille is properly attached to refrigerator
Cabinet is setting solid on all corners
Electrical Power
House power turned on
Refrigerator plugged in
Ice Maker
House water supply connected to refrigerator
Water & power couplings connected at door
No water leaks present at all connections - recheck in 24 hours
Ice Maker is turned ON.
Ice & Water Dispenser operates correctly
Front filter must be flush with filter housing (some models)
Final Checks
Shipping material removed
Fresh Food and Freezer controls set
Crisper Humidity controls set
Registration Card sent in
Adjustable
Wrench
Socket
Wrench Set
OR
Phillips head
™
Tools You Will Need:
3/8”
Fixed
Wrench
Refer to your Owner’s
Use and Care Manual for
additional information about your refrigerator.
•
Load refrigerator from side of cabinet
only.
• Do not run retaining straps over
handles.
• Do not over-tighten retaining straps.
• Never use refrigerator handles to
move the refrigerator.
• Remove tape from doors only after
unit is in place.
HAND TRUCKING
1
2
3
4
5
6
7
9
eçìëÉ
éäìãÄáåÖ
äáåÉ
t~íÉêäáåÉ=Üççâìé
WATER SUPPLY
_É=ÅÉêí~áå
íÜÉ=ï~íÉê=î~äîÉ=áë
çéÉå=~åÇ=íÜÉêÉ
~êÉ=åç=äÉ~âëK
qÜÉ=ï~íÉê=î~äîÉ
çå=íÜÉ=Ä~Åâ=çÑ
íÜÉ=êÉÑêáÖÉê~íçê
ïáää=`äáÅâL_ìòò=áÑ
íÜÉ=ï~íÉê=î~äîÉ
áë=ÅäçëÉÇK
INSTALLATION CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
•
Sides & Top..........3/8”
•
Back.......................1”
NOTE
: If you are installing your refrigerator beside a wall,
leave 1/2” minimum between hinges and wall to allow for
the door to swing open.
All four corners of refrigerator must rest firmly on a solid
floor. Your refrigerator has adjustable rollers to help level it
and to adjust the doors.
To level cabinet or change door height:
1. Remove toe grille.
2. Use a screwdriver, 3/8” wrench, or nutdriver to adjust the
rollers. To raise cabinet or door, turn screw clockwise. To
lower cabinet or door, turn screw counterclockwise.
LEVELING AND ADJUSTING
Toe Grille
Cabinet
Copper water line
from household water supply
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Steel
Clamp
Plastic Water Tubing
to Ice Maker
Fill Tube
Brass
Compression
Nut
Remove Shipping material. (Features may vary per model.)
√√√√√
See “Normal Operating Sights & Sounds”
in the
Use & Care
Manual so you understand the sounds you may hear once
your refrigerator is running.
√√√√√
Please read entire
Use & Care Manual
to become aware of
important safety instructions and to become familiar with your
new refrigerator.
√√√√√
Send in Registration card
to register your refrigerator.
√√√√√
Congratulations!
You are ready to enjoy your new refrigerator.
If you need to remove the doors to get your refrigerator in the house, please see
Door Removal Instructions in your Use & Care Manual.
Ensure icemaker to turned ON. Check to see that the Ice & Water
Dispenser is operating correctly. (See Automatic Ice & Water
Dispenser Features in
Use & Care Manual.)
Connect water supply - check for water leaks.
Turn icemaker OFF
if water supply is not connected immediately. Connecting to a
reverse osmosis system is not recommended.
SHIPPING MATERIAL
8
Ice
Water
P/N: 241631900
IF YOU ARE DISSATISFIED WITH THE INSTALLATION OF YOUR REFRIGERATOR, PLEASE CALL THE STORE YOU PURCHASED IT FROM.
(Turn to other side for Spanish version.)
Cube
Crush
Light
Filter Reset
Xtra Ice
When
changing
control
settings, wait
24 hours before
making additional
adjustments.
ON
OFF
Wire
Signal Arm
