Frigidaire FTE5200SBRE, Руководство по эксплуатации

Страница: 10 / 16

10
USING YOUR
APPLIANCE
TWIST ICE & SERVE
To use, remove the tray, fi ll
with water and place back
in the freezer. Once ice has
formed (approximately
3 hours) simply twist the
knob at the front clockwise
until the ice drops into the bin below.
A larger bin is provided in some bottom mount models
along with an ice scoop.
Mounting the Twist Serve to the Other Side of the Freezer.
Note: this is only possible on Top Mount models.
1. Remove the ice bin and ice cube tray. If the ice tray
assembly is frozen to the carriage, simply squeeze the
tray and shelf together to break the ice.
2. Before you remove the ice carriage, remember to
disengage it from the glass shelf (as shown), as it may
result in damage to the assembly.
3. Remove the centre runner by disengaging it at the
front of the shelf, and removing it from the rear.
4. Refi t the runner in to the rear
of the shelf on the right hand
side and then engage the
front (as shown).
5. Fit the carriage by sliding
it into the runners until the
front of the carriage engages
with the shelf.
6. Refi t the ice tray and ice bin.
5. Fit the carriage by sliding it into the runners until the
front of the carriage engages with the shelf.
6. Refi t the ice tray and ice bin.
Insert into the slot at
the rear of the shelf
Then engage
into the front of
the shelf
SPILLSAFE™ GLASS SHELVES (WHERE FITTED)
Spillsafe™ glass shelves keep spills on the shelf. A shelf
retaining system minimises accidental movement of
shelves and they can be adjusted to various heights.
Spillsafe™ glass shelves are not to be used as slide out
shelves. To remove the shelves, gently pull them forward
until the shelf comes clear of the shelf guides. To return the
shelf, make sure there is nothing behind that may obstruct
movement. Gently push the shelf into the cabinet and back
into position.
BOTTLE HOLDER
The bottle holder can be used to store various types of
bottles like wine or beer. Bottles should be stored with the
bottom end towards the back of the refrigerator. Selected
models are supplied with a chrome, full-width wine rack.
FREEZER DRAWERS (WHERE FITTED)
The drawers are mounted on telescopic extension slides, to
enable full access to the content in the drawer. Clear plastic
fronts provide easy visibility of foods.
To remove the drawer for cleaning,
1. Empty food from the drawer.
2. Remove the drawer by pulling it forward and lifting
the front to unhook it from the slides. Once you have
removed the drawer, ensure the slides are pushed back
so they are fully closed.
WARNING
Never close the door while the telescopic slides are
extended. This may damage the slide and/or refrigerator
or cause the slide to become disengaged from the
refrigerator.
To replace the drawer,
1. With the telescopic slides pushed in all the way.
2. Slide the drawer into place over the slides and push
the bin in until it stops. The bin will not be closed all the
way.
3. Open the bin to access the fi nger tabs at the ends of
the telescopic slides, on each side of the bin. Using your
thumb and forefi nger, lift the bin over the end of the
slide and clip in place. If the drawer is not fully engaged
on the slide, it’s possible the drawer won’t stay on the
slide if fully extended.
4. Fully close the bin.
When replacing the drawers after cleaning, we recommend
fi tting the lower drawer fi rst.
The end of slide must
be clipped into place