IF YOU ARE DISSATISFIED WITH THE INSTALLATION, PLEASE CALL THE STORE YOU PURCHASED IT FROM.
TO BE REMOVED BY THE CUSTOMER AFTER INSTALLATION IS COMPLETE
INSTALLATION CHECKOFF LIST
Doors
Handles are secure and tight
Door seals completely to cabinet on all sides
Freezer door is level across the top
Leveling
Refrigerator is level, side to side and tilted 1/4” (6mm) front to back
Toe grille is properly attached to refrigerator
Cabinet is setting solid on all corners
Electrical Power
House power turned on
Refrigerator plugged in
Ice Maker
House water supply connected to refrigerator
No water leaks present at all connections - recheck in 24 hours
Ice Maker is turned ON.
Final Checks
Shipping material removed
Fresh Food and Freezer controls set
Crisper Humidity controls set
Registration Card sent in
$GMXVWDEOH
:UHQFK
6RFNHW
:UHQFK6HW
25
3KLOOLSV KHDG
™
Tools You Will Need:
µ
)L[HG
:UHQFK
Refer to your
Owners Use and Care Manual
for additional
information about your refrigerator.
•
Load refrigerator from side of cabinet
only.
• Do not run retaining straps over
handles.
• Do not over-tighten retaining straps.
• Never use refrigerator handles to
move the refrigerator.
• Remove tape from doors only after
unit is in place.
HAND TRUCKING
1
2
3
4
5
6
7
9
,SYWI
TPYQFMRK
PMRI
;EXIVPMRILSSOYT
WATER SUPPLY
&IGIVXEMR
XLI[EXIVZEPZIMW
STIRERHXLIVI
EVIRSPIEOW
8LI[EXIVZEPZI
SRXLIFEGOSJ
XLIVIJVMKIVEXSV
[MPP'PMGO&Y^^MJ
XLI[EXIVZEPZI
MWGPSWIH
INSTALLATION CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
•
Sides & Top..........3/8”
•
Back.......................1”
NOTE
: If you are installing your refrigerator beside a wall,
leave 1/2” minimum between hinges and wall to allow for
the door to swing open.
All four corners of refrigerator must rest firmly on a solid
floor. Your refrigerator has adjustable rollers to help level it
and to adjust the doors.
To level cabinet or change door height:
1. Remove toe grille.
2. Use a screwdriver, 3/8” wrench, or nutdriver to adjust the
rollers. To raise cabinet , turn screw clockwise. To lower
cabinet, turn screw counterclockwise.
LEVELING AND ADJUSTING
Toe Grille
Cabinet
Remove Shipping material. (Features may vary per model.)
√
See “Normal Operating Sights & Sounds”
in the
Use & Care Manual so
you understand the sounds you may hear once your refrigerator is
running.
√
Please read entire
Use & Care Manual
to become aware of important
safety instructions and to become familiar witrh your new refrigerator.
√
Send in Registration card
to register your refrigerator.
√
Congratulations!
You are ready to enjoy your new refrigerator.
Ensure icemaker to turned ON.
P/N: 240568300
SHIPPING MATERIAL
When changing
CONTROLS
, wait 24 hours
before making additional adjustments.
Connect water supply - check for water leaks.
Turn icemaker OFF
if water supply is not connected immediately. Connecting to a
reverse osmosis system is not recommended.
8
If you need to remove the
doors to get your refrigerator
into the house please see
“Door Removal and Reversal
Instructions” in your
Use &
Care Manual.
