3
30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS
(For 3 Wire, 60 Hz. Systems)
A. Remove the 2 screws and remove terminal box
cover.
B.
Remove the 3 loose nuts (after you removed the
rubber band) on the terminal block using 3/8"
nut driver or socket.
C. Attach cable or pigtail to the 3 studs on terminal
block, as local codes require.
The neutral wire
(white) or center wire must be connected to
center terminal.
D. Reinstall terminal box cover.
Do not loosen nuts which secure the
factory installed range wiring to terminal block while
connecting range. Electrical failure or loss of
electrical connection may occur.
GROUNDING INSTRUCTIONS
A ground link is installed on this range which connects
the center terminal of the terminal block (neutral) to the
chassis. The ground link is connected to the range by the
center ground screw. The ground link must not be
removed unless national or local codes do not permit use
of the ground link.
NOTE:
If the ground link is removed for any reason, a
separate ground wire must be connected to the separate
ground screw attached to the range chassis, and to an
adequate ground source.
If used in a mobile home or if local codes do not permit
grounding through the neutral, use ground lead or
ground screw to ground unit in accordance with local
codes. Connect neutral to branch circuit.
To Remove Ground Link:
1.
Remove ground link
screw using a Phillips
screwdriver. Save screw
for future use.
2.
Bend up ground link so
that it does not contact
the range.
7. Wiring Instructions – 4-Wire Supply Cable
(Mobile Homes)
A. Remove the 2 screws and remove terminal box
cover.
B.
Remove ground link from terminal box and from
appliance frame. Retain ground screw.
C. Connect ground wire (green) of copper power
supply cord to frame of appliance with ground
screw, using hole in frame where ground strap
was removed (see Figure 3).
D. Connect neutral (white) wire of copper power
supply cord to center silver colored terminal of
terminal box, and connect the other wires to
outer terminals using the 3 loose nuts on the
terminal block to terminal box using 3/8" nut
driver or socket.
E.
Reinstall terminal box cover.
Figure 2
Figure 3
