19
Pre-Operation Leak Testing
GENERAL INFORMATION
Although all gas connections on the grill are leak tested prior to shipment, a complete gas tightness check must be
performed at the installation site due to possible shifting during shipment, installation or excessive pressure
unknowingly being applied to the unit. Periodically check the whole system for leaks and immediately check the
system if the smell of gas is detected.
BEFORE TESTING
Do not smoke while leak testing. Extinguish all open flames. Never leak test with an open flame.
Mix a solution of equal parts mild detergent or liquid soap and water.
TESTING
1.
Turn off the burner control knobs.
2.
Turn the top knob of the fuel supply cylinder counterclockwise (right to left) two (2) rotations to open.
3.
Apply the soap solution to connections of the fuel supply assembly. If no soap bubbles appear, there is no gas
leak. If bubbles form at the connections, a leak is detected. If a leak is detected, immediately turn off the gas
supply, tighten any leaking fittings, turn gas on, and repeat steps 1-3.
4.
Turn off the knob on the fuel supply cylinder.
5.
Turn on the burner control knobs for a moment to release the pressure in the hose, then turn the control knobs
back off.
6.
Wash off soapy solution with cold water and towel dry.
Check all gas supply fittings before each use and each time the gas supply cylinder is connected to the regulator.
Have a qualified service technician leak test the grill any time a part of the gas system is replaced.
Also it is recommended to perform a leak test at least once a year whether or not the L.P. gas supply cylinder has
been disconnected.
NOTE: When leak testing this appliance, make sure to test and tighten all loose connections, including the
side burner. A slight leak in the system can result in a low flame, or a hazardous condition. Most L.P. gas
tanks now come equipped with a leak detector mechanism internal to the tank; when gas is allowed to
escape rapidly, it shuts off the gas supply. A leak may significantly reduce the gas flow making the grill
difficult to light or causing low flames.
NOTE: If you cannot stop a gas leak turn off the gas supply and call your local gas gas company or the
dealer from which you purchased the appliance. If necessary, replace the faulty part with the
manufacturer’s recommended replacement part. A slight leak could cause a fire.
