Frigidaire Affinity 6000 Series, Руководство по обслуживанию, Страница: 57 / 74

Section 4 Component Teardown
4-15
Suspension Springs Removal
1. Disconnect the washer from the electrical supply
and remove the top panel.
2. It is necessary to hook the top of the spring, raise it
about 1” to release the top hook from the center
brace flange, then allow it to drop about 6” to
relieve the spring pressure and then unhook the
other end of the spring from the tub.
(See Figure 4-59)
To do this a strong rod at least 8” long with a hook
on one end and a handle on the other is needed,
such as the one shown here made from a paint
roller. (See Figure 4-60)
Top Center Brace Removal
1. Disconnect the washer from the electrical supply
and remove the top panel.
2. Release the tub springs and slide the water valve
assembly
back.
3. Remove the (4) screws, two on each end, and the
(2) screws holding the detergent dispenser housing
to the brace. (See Figure 4-61)
4. Raise the brace to disengage the tabs on the brace
from the side panels and slide the brace backward
to release the tabs on the brace from the slot in the
detergent dispenser housing. (See Figure 4-62)
Figure 4-59.
Figure 4-61.
Figure 4-62.
Figure 4-60.
Screws
Tabs Securing
Detergent
Dispenser