Frigidaire Affinity 6000 Series, Руководство по обслуживанию, Страница: 22 / 74

Section 2 Installation Information
2-4
Water Supply Requirements
Hot and cold water faucets MUST be installed within 42
inches (107 cm) of the washer’s water inlet. The faucets
MUST be 3/4 inch (1.9 cm) with threading for laundry
hose connection. Water pressure MUST be between 30
and 120 psi. Pressure difference between hot and cold
cannot be more than 10 psi. The local water depart-
ment can advise the customer of line water pressure.
Drain System Requirements
1. Drain capable of eliminating 17 gals (64.3 L) per
minute.
2. A standpipe diameter of 1-1/4 in. (3.18 cm)
minimum.
3. The standpipe height above the floor should be:
Minimum height: 24 in. (61 cm)
Maximum height: 96 in. (244 cm)
Unpacking Unit
1. Temporarily remove door tape.
2. Open washer door and remove everything from
drum.
3. Close door and reapply door tape.
4. Using a rug, blanket or piece of cardboard to
protect the floor, carefully lay washer on its back.
5. Remove styrofoam base and shipping plug and set
them
aside.
6. Carefully return washer to an upright position.
7. Carefully move the washer to within 4 feet (1.3 m)
of its final location.
8. Remove the following from back panel of washer:
4 shipping bolts, 4 spacers and 2 metal “P” clamps.
9. Remove the 4 plugs from the literature pack located
in the drum and install them in the holes vacated by
the packing spacers .
Figure 2-3. Standpipe Dimensions
Figure 2-4. Unpacking Unit
Drain hose attached to washer can reach a 90 inch
(229 cm) high standpipe. For higher standpipe, use
hose P/N 134369410, available from an authorized
parts distributor.
NOTE
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one per-
son move or lift the washer.
CAUTION
If the washer is to be transported at a later date,
the shipping support hardwaremust be reinstalled
to prevent shipping damage.
NOTE