6
CONTROLS AND SETTINGS
1
Cycle times are approximate and
will vary with options selected.
Hot water is necessary to activate
dishwasher detergent and melt
fatty food soils. An automatic
sensor will check the incoming
water temperature and, if it is
not hot enough, the cycle will be
lengthened for automatic water
heating in the main wash and final
rinse of all cycles. This happens
even when
High Wash Temp
option
has not been selected. When
High
Wash Temp
is selected, an even
higher temperature will be reached
to handle heavier soil loads.
2
START/Cancel Button
When cycle and options are
selected, LEDs of selected cycle
and options are illuminated. To start
the cycle, press the
START/Cancel
button and immediately close the
dishwasher door.
Press and hold the
Cancel
button for
3 seconds if you have selected your
cycle and options and decide to
cancel. The unit will go into stand-
by mode, which all LEDs will go out
You can cancel a cycle anytime
during the cycle. Press and hold the
START/Cancel
pad for 3 seconds.
The light above the cycle and option
selected will go out, and the
START/
Cancel
light will remain illuminated,
the dishwasher will start a 90 second
drain. At the end of the drain, select
the next desired cycle.
CAUTION
Property Damage Hazard
Before starting dishwasher be sure that
the water is connected and turned on.
Failure to do so may cause damage
to the pump seal and result in water
leakage.
Wash Cycle Selections
NOTE
Your dishwasher uses a DishSense
TM
Technology to understand how much
food is on the dishes and then adjusts
the cycle accordingly.
Recommended Cycle for typical
use:
The
Normal Wash
cycle with its factory
default options of normal temperature
and heated dry together provide the
best all around performance. This cycle
selection is recommended for everyday
use and is suitable for a large range of
both dish load sizes and food quantities
remaining on those dishes.
2
3
4
5
6
7
2
3
4
5
6
7
1
1
NOTE
Lights on the console will remain on
once the door is shut and wash cycle
begins. If it is preferred to have the
lights turn off while cycle is running see
Console Lights section for instructions.
