PULSE915-LRW_User_Manual
Page
19
/
23
5.1.3
Entering Configuration Mode
PULSE915-LRW terminal can be activated by magnet to enter configuration mode. Both the
wired configuration mode and wireless configuration mode need to be activated before
parameters configured.
The reed switch inside the product is triggered by the magnet to put the product into the
configuration mode, and then the configuration command must be sent within 30 seconds. If
the product does not detect the configuration command in 30 seconds, the configuration
mode will be exited. Once the command is received, the product will keep in configuration
mode for another 30 seconds.
The trigger position is shown in the figure below.
Figure 5- 1 Magnet activation position
The time that magnet triggers the reed switch to connect (the duration from connect to the
break) and the corresponding functions are shown in the following table:
Magnet hold time
Features
Remarks
2s-4s
Report data once
Typically 3s
4s-9s
Configuration mode
Typically 5s
