En
gl
is
h
Chime tune selection
The receiver chime tune can be changed by pressing the
‘ ’ button.
Chime tune options are as follows:
■
Two note bell (Default tune for door camera)
■
Saxophone (Default tune for second door camera or
bell push)
■
Single note bell
■
Knock.
The ‘ ’ button changes the chime tune for a second
door camera or a door push
Night operation
In good daylight conditions, the receiver displays a
colour picture. In low lighting or at night the display
automatically switches to black and white. Infrared
LEDs illuminate the caller, so they can be viewed on the
receiver even when surrounded by complete darkness.
Low camera battery indication
When the batteries in the door camera are running low,
the receiver indicates this with a double beep warning
tone that follows the chime when a visitor presses the
call button. Replace the batteries in the door camera
within one week of a low battery alert.
Tamper alert tone
If someone attempts to remove the door camera by
unscrewing the cover screws, the tamper alert tone
is triggered, beeping for 30 seconds. Check outside
immediately.
Press any button on the front of the receiver to stop
the alert tone. The alert tone is unaffected by the chime
volume switch.
Note: The alert is also triggered when you undo the cover to
replace batteries in the door camera.
MIC volume
[For future use] The topmost control along the side
(see diagram) will control the volume produced from a
microphone. Adjust for optimum listening level.
Scan button
[For future use] When used in a multi-camera system,
this button scans through available pictures.
Privacy
Remember that this product uses the public airwaves,
and that the 30-second duration video signal from the
door camera(s) can be picked up by nearby 2.4GHz video
receiving devices.
DOOR CAMERA
Motion sensor
The PIR (‘Passive InfraRed’) sensor activates the
door camera automatically. The receiver produces a
‘ping’ sound and displays the door camera image for
approximately 30 seconds.
If the motion sensor is not required, then it can be
disabled.
To switch the motion sensor off, press and hold the call
button on the camera for more than ten seconds. The
confidence indicator blinks rapidly to confirm that the
motion sensor is disabled.
To switch the motion sensor back on, press and hold the
call button for more than ten seconds, the confidence
indicator remains on for two seconds to confirm.
Note: Power loss to the camera or a change of batteries will
reset the sensor back on.
G-8
