P
a
g
e
| 30 of 40
FREMCO A/S
ELLEHAMMERVEJ 14
|
DK9900 FREDERIKSHAVN, DENMARK
|
VAT NO.: DK30815416
TEL45 7230 1213
|
|
WWW.FREMCO.DK
11.5.
CONFIGURATION AND UPDATE OF TABLET AND CONTROLLER
A Samsung Tablet is included (placed in the controller) and is setup from the factory to function with the
Controller in normal mode: The tablet setup a Hotspot and the controller connects to this. In offline mode,
the tablet connects to the controllers AP instead.
Normally, this is handled automatically by the Fremco App, but if this for some reason does not work, one can
setup the controller to bypass the app, and run in the normal chrome browser (or on another android device).
To get the most out of the controller, the end user must setup the tablet and controller for their specific
needs and environment.
The tablet uses the Android operating system. An arbitrary Android devices, such as a modern smart phone or
tablet, should be able to function as well.
Setup Wi-Fi on Tablet
To setup a connection to the controller (factory
default).
•
SSID / Password of controller, the specific
values can be found on the yellow label on the
control unit under the tablet.
•
At office, set SSID / Password of an access
point with internet connection where the
controller will be when not in use.
Normal Mode
In normal mode, the controller connects to the tablet.
Enable hotspot on the tablet.
Please note:
some android devices will only allow
hotspot mode when there is a sim-card in the device.
Ensure controller is on and ready.
set:
•
Hotspot SSID = “hotspot
-
XXXX
” where
XXXX
is the 4 last digits of the controllers
mac address.
•
Hotspot Password = “password
-
wpa2aes”
Find the specifics on the yellow label on the controller
under the tablet.
Please note:
that the MicroFlow Log app will always
use normal mode, but it will not set the hotspot SSID
and password, if these for some reason has been
changed on the tablet, you need to set back to the
values of the yellow label on the controller.