freightliner Run Smart ECASCADIA PE116DC 2022, Руководство по обслуживанию, Страница: 83 / 100

46–00 Safety Precautions
Safety Precautions in this section apply to all
procedures within this group.
DANGER
Electric vehicles are equipped with a high-voltage
system. Do not attempt any type of electrical work
on the vehicle unless you have completed HV3
Daimler Safety Training. Failure to do so could
cause severe personal injury or death.
When working on the vehicle, shut down the
engine or motor, set the parking brake, and chock
the tires. Before working on the vehicle, always
place jack stands under the frame rails to ensure
the vehicle cannot drop. For an electric vehicle,
decommission the vehicle and verify the high-
voltage system is shut down. Failure to follow
these steps could result in serious personal injury
or death.
46–01 Drag Link Inspection
WARNING
All steering system components are critical for
safe operation of the vehicle. Failure to maintain
the steering system as specified may result in
loss of steering control, which could lead to
personal injury and property damage.
1. Park the vehicle on a level surface, shut down
the vehicle, and set the parking brake. Chock the
tires.
2. Have someone turn the steering wheel from left
to right. Check for movement between the ball
stud end and the pitman arm, and between the
ball stud end and the steering arm.
If the ball stud end is loose, replace the drag
link.
3. Check the ball stud castle nut for looseness.
If the castle nut is loose, replace it and the cotter
pin. Tighten the new castle nut as follows:
•
3/4–16: 90 to 180 lbf·ft (122 to 230 N·m)
•
7/8–14: 160 to 300 lbf·ft (217 to 407 N·m)
4. Inspect the boot of the drag link at both the
pitman arm and the steering arm end for cracks,
splits, or other damage. Replace the boot if
needed.
5. Grasp the drag link near the pitman arm end,
then push and pull laterally to check for axial
movement in the ball stud end. If it is loose,
replace the drag link. See
Group 46 of the
eCascadia Workshop Manual for replacement
instructions. If there is 1/8-inch (3-mm)
movement or more, do not drive the vehicle until
the drag link is replaced.
46–02 Power Steering Fluid
and Filter Change
WARNING
Fill only with approved clean fluid. Failure to use
the proper fluid could cause seal deterioration and
leaks. Fluid leaks could eventually cause loss of
power steering assist. This could lead to an
accident resulting in personal injury or property
damage. Wear eye protection when changing the
fluid and filter.
1. Set the parking brake and chock the rear tires.
2. Raise the front of the vehicle and support it with
jack stands.
3. Put the vehicle in neutral.
4. Open the hood.
5. Wipe down the area around the steering gear
and related hydraulic lines.
6. Place a drain pan under the steering gear and
power steering reservoir.
7. Remove the pressure line and return hose,
shown in
Fig. 1 , from the steering gear and allow
the oil to drain.
8. Remove the filter cap from the reservoir, then
remove and discard the filter.
•
Filter caps with a separate retaining ring
have a threaded connection with the filter.
Unscrew the filter and discard it.
•
One-piece filter caps do not have a
threaded fit with the filter. Pull off the filter
and discard it.
Steering
46
eCascadia Maintenance Manual, March 2022
46/1