freightliner PX113064S T 2016, Руководство пользователя

Страница: 182 / 236

Cleaning and Disinfecting Cab
Surfaces
Cleaning and Disinfecting Safely
The following guidelines are for cleaning and
disinfecting commonly touched surfaces on the inside
and outside of a vehicle.
For best results, follow cleaning and disinfecting
procedures fully and consistently. Ensure there is
adequate ventilation when using chemicals.
•
Doors and windows should remain open when
cleaning inside the vehicle.
•
When cleaning and disinfecting, individuals
should wear disposable gloves compatible with
the products being used as well as any other
personal protective equipment (PPE) required
according to the product manufacturer’s
instructions and the safety data sheet (SDS).
•
Gloves and any other disposable PPE used for
cleaning and disinfecting the vehicle should be
removed and disposed of after use.
•
Wash hands with soap and water for at least
20 seconds immediately after removal of
gloves and PPE, or use an alcohol-based hand
sanitizer with at least 60 percent alcohol.
Cleaning and Disinfecting High-Touch
Surfaces
NOTE: Depending on how a vehicle is used, it
may be helpful to create an inclusive checklist
of high-touch surfaces to regularly clean.
To clean surfaces, soak a microfiber cloth with a
detergent/water solution, wring the cloth out, and
wipe down high-touch areas. Allow the detergent
water/solution to sit on the surface for 20-30 seconds
before using a fresh microfiber cloth slightly
dampened with water to remove it.
After this soap and water wash, Freightliner
recommends the use of either a dilutable or ready to
use quaternary ammonium based disinfectant on
vehicle interior and exterior surfaces.
IMPORTANT: Follow the manufacturer’s
instructions for using a disinfectant as these
vary by product.
NOTICE
Any disinfectant dispensed by a pressurized
aerosol container is not recommended. The
direct spray of liquids onto the vehicle’s interior
panels, electronic components, or permeable
materials is not recommended.
Using an aerosol disinfecting spray may cause
damage to parts of the vehicle.
Examples of either a dilutable or ready to use
quaternary ammonium based disinfectant include:
•
Lysol® Deodorizing Disinfectant Cleaner
•
Fantastik® Disinfectant Multi-Purpose Cleaner
•
Hillyard Vind Disinfectant
All exterior high-touch surfaces should be cleaned
with soap and water before applying disinfectant.
Exterior high-touch surfaces include, but are not
limited to, the following:
•
grab handles
•
door handles
•
hood latches and handles
•
trailer glad hands
Freightliner recommends applying the disinfectant
solution to a microfiber cloth until it is damp but not
dripping and then wiping down high-touch areas.
Take care to fully wet surfaces with the disinfectant,
and ensure that it remains wet for the period of time
stipulated by the disinfectant manufacturer to
effectively disinfect the surface. Afterwards, if
necessary, wipe off excess disinfecting solution with
a new clean cloth.
If an interior high-touch surface is visibly dirty, clean
it before applying disinfectant; if it appears clean,
wipe down the area with disinfectant.
Interior high-touch surfaces include, but are not
limited to, the following:
•
grab handles
•
seats
•
arm rests
•
steering wheel
•
switch pods
•
shift knob
•
door handles
Vehicle Appearance and Care
16.1