Using SERDES1 Protocol: 5205 (0x1455)
fman_port_enet_if:71: port(FM1_DTSEC3) is OK
fman_port_enet_if:77: port(FM1_DTSEC4) is OK
Flash: 128 MiB
NAND: 512 MiB
MMC: FSL_SDHC: 0
EEPROM: NXID v1
PCIe1: disabled
PCIe2: Root Complex no link, regs @ 0x3500000
PCIe3: Root Complex no link, regs @ 0x3600000
In: serial
Out: serial
Err: serial
Net: Fman1: Uploading microcode version 108.4.15
FM1@DTSEC1, FM1@DTSEC2, FM1@DTSEC3, FM1@DTSEC4, FM1@DTSEC5, FM1@DTSEC6, FM1@TGEC1
Hit any key to stop autoboot: 0
=>
NOTE
U-Boot is updated frequently; therefore, the details given above may change slightly over
a period of time.
4.3 Restart board
To restart or reset the system, use the reset button next to the UART port (RJ45 without LED).
5 Switch configurations
In the LS1043ARDB, the configuration switches are arranged along the edge of the board. Use the following figure as a
reference.
SW5
SW4
SW3
Figure 3. DIP switch locations
With the board positioned as shown above, switches read "SW5 SW4 SW3" moving from left to right. For these types of DIP
switches:
• When a switch is up (OFF), the value is 0
• When a switch is down (ON), the value is 1
Switch configurations
QorIQ LS1043A Reference Design Board Quick Start, Rev. 1, 11/2015
4
Freescale Semiconductor, Inc.
