Fred’s Lab TOORO, Руководство пользователя и обслуживания

Страница: 15 / 66

5 PRESET & MULTI MANAGEMENT
5 Preset & Multi Management
The T¨ o¨ or¨ o is a multi-timbral device that can store 100 presets and 10 multis. All memory
locations can be overwritten by the user, so the factory patches can be overwritten.
An important concept to understand is that there is no separation between preset and
multi mode, the
T¨ o¨ or¨ o always operates in multi mode.
ˆ
A preset is a single sound with a set of parameters for oscillators, filter, shaper,
LFOs, envelopes, amplifier, arpeggiator and modulation matrix.
ˆ
For operations on presets, the alternate mode must be disabled. Make sure that the
ALT LED is not lit.
ˆ
A multi is a set that references 4 presets as parts, a mixer with volume and balance,
the MIDI channel settings and an fx section.
ˆ
For operations on multis, the alternate mode must be enabled. Make sure that the
ALT LED is lit.
5.1 Selecting a Part
Before selecting or editing a preset, it is important to select the part currently edited. By
default, part 1 is selected.
Press and hold the SYSTEM button. Then use the first parameter encoder labelled
PART to select the part. The display will show P1..P4 while the encoder is turned.
Part selection 1..4
5.2 Setting the MIDI Channel
You can set a separate MIDI channel for each part to receive notes and other messages
from an external keyboard, computer or sequencer. In addition,
omni mode can be
selected to receive MIDI data from all channels.
Press and hold the SYSTEM button. Then use the second parameter encoder labelled
CHANNEL to select the midi channel. The display will show 01..16 or OM while the
encoder is turned.
Channel 1..16 Omni mode
Note: when omni mode is selected, channel 1 is used to transmit parameter
changes.
5.3 Selecting a Preset
There are 2 ways to select a preset:
ˆ
Press the PRESET button to increment the preset number by one.
15