Freddy Superminor, Руководство пользователя

Страница: 12 / 39

12
FPQ41 Superminor Issue 1
4. Replace the filter hood:
Fit the filter hood on the Superminor turret
so that the four clips line up.
Work on one clip at a time.
Raise the lower part of the clip to allow you
to place the top part of the clip over the
edge of the filter hood
(1).
Push down the lower part of the clip (2) to
secure the filter hood to the Superminor.
Repeat this for each clip.
Figure 4-6: Replace the filter hood
4.3 Fit the suction hose
Before you use the Superminor, you must first
connect the suction hose to the pipe on top of
the Superminor filter hood.
One end of the hose has a 51 mm CAM lock
fitting which has two clamps. This is the end to
attach to the Superminor.
Make sure the clamps on the hose are raised
away from the end of the hose.
Push the end of the hose onto the pipe on top
of the Superminor filter hood.
Figure 4-7: Fit the suction hose
Pull each clamp in turn towards the hose to
secure it in place.
Figure 4-8: Secure the suction hose
To remove the suction hose from the
Superminor, pull the hose clamps away from
the hose towards the Superminor.
Pull the hose away from the Superminor.