FRC Flush Mount ICA400 Series, Руководство пользователя

Страница: 8 / 20

ICA100 Rev171109
8
ICA200/300 SERIES INSTALLATION
Note: In a three-way system (ICA300) master station A has transmit priority
over master station B and the remote station.
Note: Mounting hardware is not included, 1/4-inch hardware is recommended.
Pre-Installation
Note: The mounting bracket can be removed by unscrewing the adjustment
knobs at the side of the station box (Refer to Figure 3).
1. Measure and mark station box locations for mounting bracket installation.
Refer to Figure 4 for layout and dimensions.
2. Drill four mounting holes at each station box location for mounting hardware.
Note: Pre-installed apparatus wiring can be used. The intercom connections
are one-to-one. The yellow wire is shield.
3. Install the cable (with 3-pin connector) between remote and master station box
locations. Refer to Figure 5 or 6 for wiring details.
4. For three-way system (ICA300) install the cable (with 5-pin connector) between
master stations A and B box locations. Refer to Figure 6 for wiring details.
Install Remote Station
1. Place mounting bracket in position and secure with four screws.
2. If bracket was removed from box, place remote station box in position and
install rubber bushings and mounting knobs.
3. Connect station box 3-pin Molex connector to cable connector.
Install Master Station(s)
1. Place mounting bracket(s) in position and secure with four screws.
2. If bracket was removed from box, place master station(s) in position and install
rubber bushings and mounting knobs.
3. Connect station box 3-pin Molex connector to cable connector.
4. For three-way system (ICA300) connect station box 5-pin Molex connector to
cable connector.
5. Connect black wire to ground.
6. Connect red fused wire to +12 VDC.
7. For three-way system repeat steps 4 through 6 at master station B.