Page | 17
Troubleshooting: Wastewater Tanks
Problem
Cause/Solution
The RV is hooked up to the city water
connection and water comes out of the toilet
and/or the ventilation pipe on the roof.
You accidentally connected the water hose to the sewer flush.
Turn off the water and connect the hose to the "City Water"
hook-up.
The wastewater tanks are indicated to be full
although they have just been emptied.
-
Paper, grease or food can get stuck on the sensors inside the
tank causing false readings.
-
There is no clog if water can be heard running through the
sewer hose.
HEATING/AIR CONDITIONING
The RV furnace runs on propane. However, the fan runs on electrical power. The fan will operate on both 12V
and 110V (shore power). It is preferable to have a power hook-up in order to heat the RV.
CAUTION:
-
Don’t let your heater run for an extended period of time WITHOUT being on shore power. If
your vehicle is not connected to a 110V power grid, the heater/fan can overload the system. The
fan consumes a lot of power and can quickly drain the coach batteries. The renter is liable for
repairs due to battery overload and/or any time loss.
-
The motorhome must be hooked up to a 110V/30AMP power grid in order to operate the roof
air condition.
THERMOSTAT
Furnace and air conditioner are operated by a joint thermostat. The display indicates the mode and the room
temperature. The display of this
Dometic Capacitive Touch Thermostat
will come on when the mode button is
pressed once. It will show the
Inside Temperature
in
OFF mode
only!
The air conditioning unit in the ceiling of the RV has no controls. Use sliders (
O
)
to open
or close vents.
Troubleshooting: Heater
Problem
Cause/Solution
The heater blows cold air.
-
The set temperature has already been reached
-
Main valve of propane tank is closed
-
Propane tank is empty
-
Fan setting is on LOW or HIGH, please turn to AUTO!
If fridge and stove are working there is no problem with the propane
supply!
Press to Power
On,
Off
and
Toggle
between
operation modes
Press
to
INCREASE
Temperature Set-Point
Press to DECREASE
Temperature Set-Point
Fan Mode Setting:
Press the Mode button until the fan mode is active. Press
the
or
button to cycle through fan speed options Low,
High and Auto. We recommend to use the
AUTO
setting!
Mode of Operation:
Press the Mode button to cycle through the available
modes
COOL
and
FURNACE
. To change the setting, press
the
button to increase and the
button to decrease the
setting.
Содержание Four Seasons C-Large
Страница 1: ...RV Type C Small Instruction Manual ENGLISH...
