aPbox Installation and Operations Manual
16
aPbox wall installation
Follow the steps below to mount the aPbox on the wall.
Step 1
Place the guide board at the planned installation position (refer to the local laws,
regulations and codes for building construction to set the minimum height of aPbox).
Use a spirit level to adjust the guide board, and then make marks at the four holes on
the guide board.
Step 2
Using a hammer drill and the appropriate drill bits for the wall material (See
),
drill a hole the same diameter as the anchor diameter, and at least 1-
1/2” deeper than
the expected embedment. Ensure that all fasteners are at least 1.5 in (38 mm) away
from the edges of masonry blocks or bricks. Clean debris out the holes.
DANGER
Do not drill electrical wires or pipes that are in the wall.
Wall
Floor
Spirit level
Mounting
Template
48 in.
(recommended)
Marker
3/8 in
≥1
-1/2in
