Franklin Electric BT4 Series, Руководство пользователя

Страница: 3 / 44

INSTALLATION
Typical Installation
3
INSTALLATION
Typical Installation
Pump Location
• Install the pump in a clean, dry, and ventilated location shielded from direct sun and precipitation.
• Provide adequate room for future servicing, protection from freezing temperatures, flooding, and
equipment drainage.
• Bolt unit down evenly on a good foundation, preferably concrete, to prevent unnecessary stresses
from pump movement.
• Install as close as possible to water source to minimize suction piping length.
Male Pipe to Male Hose Adapter
Female Hose
Male Hose
Connection
High Pressure
Hose
10 Feet
Maximum
Gun Nozzle
Weeping Type ONLY
Priming Plug
Tee 90 Elbow
Water Supply
Foot Valve
To Power
To Power
Gate Valve or Hose Bibb
Male Pipe to Male Hose Adapter
Male Pipe to Male Hose Adapter
High Pressure Hose with two
Female Connections
Service Line
Male Pipe to Male
Hose Adapter
(Suction)
(Discharge)
Gun Nozzle
Weeping Type ONLY
High Pressure Hose
Female Hose
Connection
Street Supply
Union
Valve (normally open)
Check Valve
Union
Pressure Gauge
Inlet
Booster Pump
Check Valve
Pressure Tank
Pressure Gauge
Outlet
Union
Union
Valve (normally open)
Pressure Switch
Pressure Relief Valve
Drain Valve
Service Tee
Flow
Flow
Pump Installation Vertical On Wall
Pump Installation Using Municipal Source
Pressure Gauge
Wall Hydrant
High Pressure Reinforced Hose
Hose Adapter
Service Tee
Suction Inlet
Discharge Outlet
Pressure Relief Valve
Hose Adapter
Booster Pump
Spray Nozzle
High Pressure Reinforced Hose
Pump Installation Using Wall Hydrant or Faucet Pump Installation Drawing Water from Below Pump
Connection