7
18
-05.
237
g-GB
.f
m
11. Function
11.1
Allow your hand to approach the sensor.
• Water flows.
11.2
Remove your hand from the sensor.
• Water flow stops automatically after a set flow duration.
☞
The range of the sensor and the flow duration can be adjusted with the optional
remote control (FAR Order No. 5207 10 00).
☞
Important!
Reflecting surfaces can influence the sensor. There is a risk of having permanent
reflections. ((see
for adjusting the sensor range).
“Auto-flush” function
Caution!
When the “Auto flush” function is used, the flow of water must be ensured.
• The "Auto-flush" function ensures that forced flushing takes place to exchange the
water in the tap lines after 24 or 72 hours of non-use.
• The “Auto-flush” function can only be switched on with the optional remote control
(FAR-Order-No. 5207 10 00).
• This function is switched off at the factory.
12. Controlling the Temperature
Sink mixer
with mixing lever
12.1
Set the mixing lever (a) in the desired position.
Sink mixer
with concealed mixing facility
12.2
Remove the plug (b).
12.3
Use an Allen key (c) to set the required mixed-water temperature.
12.4
Push in the plug.
[email protected] - www.hygiene-shop.eu
