Franke 2000103793, Инструкция по установке и эксплуатации

Страница: 7 / 96

7
ZMI
_001_
2000
1037
93-A
Q
CT0025
_#SE
N
_#AQ
U
_#V
1.f
m
10.9 Connect the solenoid valve to the AQUACONTACT sensor.
☞
The battery compartment or power supply and extension cable are not part of the
scope of delivery (see Accessories,
chapter 20 ).
☞
If you are using a wall-mounted power supply unit, it must be installed around 3 m
away from the shower.
10.10 Connect the AQUACONTACT sensor (g) to
– a battery compartment (h)
or
– a wall-mounted power supply unit (k).
☞
If the battery charge state is low, the LED flashes in a 20 second cycle.
10.11 Remove the protective film from the shower panel.
10.12 Seal the shower panel (e.g. with Chromol, not part of the scope of delivery,
see Accessories,
chapter 20 ).
10.13 Insert the top of the cover plate (l) into the frame tabs and fit.
10.14 Fasten the cover plate at the bottom, using screws (m).
10.15 Check the flow time and adjust where necessary (see chapter 12. ).
11. Function
☞
You can switch between time control and body reflection using the remote control
(not in the scope of delivery; see Accessories,
chapter 20 )
Time control
Triggering the flow of water
11.1 Hold your hand near the sensor.
• The water will flow.
• The water flow will stop automatically
– once the preset flow time expires
or
– after approaching the sensor once again.
☞
The flow duration is factory-set to 30 seconds.
Body reflection
Triggering the flow of water
11.2 Hold your hand near the sensor.
• The water will flow.
• The water flow will stop automatically
– once the preset flow time expires
or
– after approaching the sensor once again
or
– after leaving the sensor range.
Temperature selection