6 - Operating Instructions
This equipment is designed for use out of doors, in free air. Never place anything on or cover
the searchlight when in use as this may present a hazard.
The beam of the searchlight cannot be adjusted.
This product should not be used for any purpose other than for which it was designed.
Any modifications to the product should not be undertaken without consulting the
manufacturer.
7- Fault Finding
All fault finding must be conducted by a competent person or qualified Electrical Engineer.
Failure of LED to light.
In the event of the LED failing to light the following steps should be taken:
1)
Check that the mains supply is connected to the input of the LED driver and check all
connections as per the wiring diagram. On operation if the LED does not light, switch off
mains supply and check all fuses;
2)
Check output from the LED driver 38.5 volts.
8 - Maintenance and Servicing
In order to prolong the service life and performance of your searchlight, the following
maintenance guidelines are recommended:
◼
Maintenance checks should be conducted before every voyage or at least every three
months;
◼
Before checking, disconnect the equipment from the supply;
◼
Visually inspect the condition of the equipment;
◼
Any major or minor structural damage should be rectified immediately in order to reduce
sympathetic wear;
◼
After inspection it may be necessary to clean the inside of the searchlight. The following
procedure should be adhered to:
◼
Remove the front bezel;
◼
Clean the front glass inside and out using a proprietary glass cleaner;
◼
Clean the reflector if required;
◼
It is advisable to check all seals and gaskets for signs of degradation. Renew if necessary;
◼
Upon completing all maintenance requirements, the searchlight should be tested for full
working order (approximately 20 minutes).
◼
Every six months the external movement mechanisms i.e. lockwheels, elevation and pan
mechanisms, should be lightly lubricated.
If in any doubt as to the correct servicing procedures to adopt please contact your
distributor/agent or the manufacturer who will be able to advise the best course of
action for your product.
