8
EN
CHOOSING THE LOCATION OF THE GAS OUTDOOR HEATER.
The OUTDOORFIRE gas garden heater is a mobile device capable of movementto any place of your
choice. However, there are restrictions that must be strictly followed. The device, due to the possibility
of high temperatures on its external surfaces, especially windows, should be kept away from flamma-
ble materials, and also because of the open combustion chamber without the possibility of connecting
to chimney flues, it should be used in open spaces or in well-ventilated rooms. IT IS ABSOLUTELY PRO-
HIBITED to place the device in a position other than vertical.
Tips for proper and safe installation of the device:
•
Connect the regulator to the liquid gas cylinder so that the anti-tilt valve is in a vertical position.
Connecting it in any other way may block the gas supply to the device. To do this, use the appro-
priate tools. Tightening the regulator by hand is insufficient and may result in gas leakage. Cylinder
replacement and / or connection should take place in well ventilated areas.
•
Make sure that the rubber gaskets are in place and undamaged before connecting the gear unit. If
this is not the case, the device cannot be used until the seal has been replaced.
•
Remember that the gas cylinder should always be in an upright position and the hose connecting
the cylinder to the burner should be laid in such a way that it does not come into contact with sharp
objects or edges, as well as hot elements of the burner.
•
Check the correctness and tightness of the installed gas control control system and the entire gas
system of the device. To do this, you can use soapy water or a dedicated spray to detect gas leaks.
To check for leaks, cover with water and soap or spray any connections (cylinder- reducer, reducer
- tilting valve, tilting valve - gas hose, gas hose - gas block of the controller, gas block - copper wires
of the magneto and main burner, main burner nozzle - copper wire ) between the cylinder and the
controller, as well as those behind the gas block, and then ignite the device so that the gas also fills
the section from the gas block to the burner nozzles. If bubbles appear on the joints, it means that
there is a leak in this place.
•
Remove the glass according to the instructions on page 18, arrange the decorative elements evenly
on the burner according to the graphic (fig. 7), then reinstall them.
• ATTENTION:
Safe distances from flammable materials that should be observed in accordance
with the instructions in this manual have been established on the basis of safety tests. Flammable
materials can be called anything that can catch fire, i.e. paper, wood, all kinds of fuels, plastic,
clothing, etc. The designated space is not limited by non-flammable materials, but also applies
to flammable materials directly behind non-flammable objects exposed to contact with device.
• If you are unsure of the flammability of any material within the device, consult your fire brigade.
• Remember that fireproof materials are considered flammable despite their fire resistance.
•
They can be difficult to set on fire, but they also burn.