Fraco SEP-5000, Руководство пользователя

Страница: 68 / 89

Transport platform SEP Serie
SEP u
ser’s manual Page 68 of 89
Doc no. RD-7243-MA-001-02
9.1. Daily maintenance
•
Platform;
o Clear the platform of excess dirt, debris and snow/ice.
o
Clean the proximity detector and the end travel detecor.
o
Make sure the data plates and stickers are present, legible and in good condition on
the platform, protection mesh and anywhere required.
∞
R
EFER TO SECTION
4.10 D
ATA PLATES AND STICKERS
,
ON PAGE
31.
o
At ground level, keep the space around the working zone of the platform clean and
cleared.
o
Visually inspect the movement path of the platform and that it is clear of any
obstacles.
o
Inspect the condition of the guide rollers.
•
Protections;
o
If present, inspect the ground protection mesh. Make sure the ground is firm and
solid. Check that the protection mesh adjustable footing is well adjusted to the
ground. Add shoring if necessary.
•
Control;
o
At ground level, check that the arms and rollers of the level limit switch are in good
condition and pivot easily.
o
At every required level, make sure that the level detector pads are firmly attached
and in good working condition.
•
Additional components;
Inspect the condition of the following items. Check for jamming, deformation and
breakage;
o
Loading and unloading, tailgates of the platform.
o
Installation tailgate platform.
o
Landing doors.
o
Platform floor.
o
Railings.
o
Plinth.
o
Protection roof (if installed - optionnal).
•
Electro-mechanical;
o
Inspect the condition of the motorization.
o
Inspect the condition of the main power supply.
o
Inspect the condition of the power cables, cable guides and cable barrels. Look for
twists/derformations and sharp edges that may damage the cables.
•
Operation;
Make a movement verification and make sure that:
o
The end travel detectors are triggered at each floor and ground level.
o
The tailgates interlock locks work adequately. It must not be possible to operate
(elevate or lower) the platform when one of the doors is opened
o
All emergency stop buttons are in working condition. When pressed individually, it
must not be possible to operate (elevate or lower) the platform.
∞
R
EFER TO SECTION
7.12 E
MERGENCY STOP BUTTON
,
ON PAGE
58.
o
Platform movement immediately stops when a landing door is opened. Test all
landing doors.
o
Make sure the machine stops immediately a few seconds when reaching 10'-0" (3m)
or less from the ground during descent. When the platform resumes its descent,
make sure the sound signal works during the rest of the descent, until reaching
ground level.
o
Inspect the condition and function of the emergency descent system.
o
While operating, someone must inspect the condition of the ground and of the load
distribution elements (legs with adjustable jacks, shoring, etc.).