FPS IGP-A Series, Руководство пользователя, Страница: 3 / 32

PRODUCT DESCRIPTION
Specifications
3
PRODUCT DESCRIPTION
Submersible grinder pumps are recommended for use in basins or lift stations and are suitable for pumping
residential sewage, effluent, wastewater, and other non-explosive, non-abrasive, and non-corrosive liquids.
These pumps utilize a cutting mechanism, located on the suction side of the pump, that cuts solids into a
slurry. A semi-vortex, non-clog impeller then passes this slurry directly through the volute and into the dis
-
charge line.
Some FPS IGP series grinder pumps are equipped with a float switch that allows the pumps to operate auto
-
matically by cycling them on and off. The float switch is attached to the pump at a pre-determined tether
length of 9 inches (22.86 cm). Check the tether length on the pump to ensure it has not changed during
shipping.
This product is covered by a Limited Warranty for a period of 2 years from the date of original purchase by
the consumer. For complete warranty information, refer to
www.FranklinEngineered.com .
Specifications
NOTE: IGP-A models can be ordered without automatic floats.
Flow Rate
Model No. Volts Amps Watts HP Phase
IGP-A231-20
208-230
13.9 3200
2
1
IGP-A231-30
IGP-M231-15
IGP-M231-30
IGP-M233-30 10 1300
3
IGP-M463-30 460 4.5 1025
Gallons (Liters) per Minute at Height
Shut-Off
(ft / m)
10 ft
(3.0 m)
20 ft
(6.1 m)
40 ft
(12.2 m)
60 ft
(18.3 m)
80 ft
(24.4 m)
100 ft
(30.5 m)
120 ft
(36.6 m)
33 / 124.9 32 / 121.1 31 / 117.3 30 / 113.6 25 / 94.6 20 / 75.7 10 / 37.9 130 / 39.6