THEA-130 / 160 Sprayer Drone
User Manual
©
2019 FOXTECH All Rights Reserved
40
Concise Operation Process
1) check power cable and cable between peripherals and flight control;
2) launch ground station, and launch BY-GCS ground station;
3) switch on RC remote control equipment;
4) switch on the aircraft system and connect to the ground station;
5) calibrate the remote control, if it has been calibrated, skip;
6) calibrate the electronic governor(Do not install propellers.), if it has been calibrated, skip;
7) start the function of motor test on the ground station, and make sure the whirling and the serial number of
motors match;
8) calibrate the accelerometer, if it has been calibrated, skip;
9) calibrate the magnetic compass, if it has been calibrated, skip;
10) set flight model;
11) set protection of being out of control;
12) check if there is any warning from the ground station, analyze the reasons and solve it;
13) check if key data is normal such as attitude data, course data and GPS data, and move the aircraft to
observe whether change of data is normal;
14) check installation of external GPS and compass;
15) check installation direction of the flight control and damping;
16) check whirling direction of motors and propellers and check if they are installed firmly;
17) toggle switches of flight models and observe whether the displayed area in flight model on the ground
station switches normally;
18) set route tasks and upload, then download them and make sure the route has been planned right; If you
have any question, don’t force it to fly, please contact the technician.
Only when the position has been decided by GPS can you unlock it in the fixed-point model.
