FoxGate S6124, Руководство по управлению

Страница: 368 / 391

368
Timeout in milli-seconds [2000]
：
500
Extended commands [n]
：
n
Display Information Explanation
VRF name VRM name. If MPLS is not enabled, this field will
be left empty.
Target IP address
：
The IP address of the target device.
Use source address option[n] Whether or not to use ping with source address.
Source IP address To specify the source IP address for ping.
Repeat count [5] Number of ping requests to be sent. the default
value is 5.
Datagram size in byte [56] The size of the ICMP echo requests, with default
as 56 bytes.
Timeout in milli-seconds [2000]
：
Timeout in milli-seconds, with default as 2
seconds.
Extended commands [n]
：
Whether or to use other extended options.
41.5 ping6
Command: ping6 [< dst-ipv6-address > | host < hostname > | src < src-ipv6-address >
{< dst-ipv6-address > | host <hostname >}]
Function: To check whether the destination network can be reached.
Parameters: < dst-ipv6-address > is the target IPv6 address of the ping command.
< src-ipv6-address > is the source IPv6 address where the ping command is issued.
< hostname > is the target host name of the ping command, which is limited to be less
than 30 characters.
Default: Five ICMP6 echo request will be sent by default, with default size as 56 bytes,
and default timeout to be 2 seconds.
Command Mode: Normal user mode
Usage Guide: When the ping6 command is issued with only one IPv6 address, other
parameters will be default. And when the ipv6 address is a local data link address, the
name of VLAN interface should be specified. When the source IPv6 address is specified,
the command will fill the icmp6 echo requests with the specified source address for ping.
Example:
(1) To issue ping6 command with default parameters.
Switch>ping6 2001:1:2::4