FoxGate S6124, Руководство по управлению

Страница: 365 / 391

365
Chapter 41 Commands for Show
41.1 clear logging
Command: clear logging sdram
Function: This command is used to clear all the information in the log buffer zone.
Command Mode: Admin Mode
Usage Guide: When the old information in the log buffer zone is no longer concerned, we
can use this command to clear all the information.
Example: Clear all information in the log buffer zone sdram.
Switch#clear logging sdram
Related Command: show logging buffered
41.2 logging
Command: logging {< ipv4-addr > | <ipv6-addr> } [facility < local-number >] [level
< severity >]
no logging {< ipv4-addr > | <ipv6-addr> } [facility < local-number >]
Function:
The command is used to configure the output channel of the log host. The ―no‖
form of this command will disable the output at the log host output channel.
Parameter: < ipv4-addr > is the IPv4 address of the host, <ipv6-addr > is the IPv6 address
of the host; < local-number > is the recording equipment of the host with a valid range of
local0
～
local7,which is in accordance with the facility defined in the RFC3164; < severity >
is the severity threshold of the log information severity level, The rule of the log
information output is explained as follows
：
only those with a level equal to or higher than
the threshold will be outputted. For detailed description on the severity please refer to the
operation manual.
Command Mode: Global Mode
Default: No log information output to the log host by default. The default recorder of the
log host is the local0, the default severity level is warnings.
Usage Guide: Only when the log host is configured by the logging command, this