Foxconn
RPQN O-RU Installation and Operating Guide
2. Regulation and Certification
2.1 Environmental and safety requirement
Environmental and safety requirements for RPQN O-RU hardware installation.
⚠
Warning: Electric Shock.
Please notice that the RF ports should be connected to a 50 Ω load (for example, feeder with an
antenna) before powering on the RPQN O-RU.
p
Warning: Hot parts.
To avoid the risk of hot parts, please use the RPQN O-RU with caution, and wait at least 30 minutes
before handling the RPQN O-RU after powering off.
💡
Only trained and qualified personnel are recommended to install, operate, maintain or handle the
RPQN O-ORU, and please carefully read the safety information applicable to this product.
Only install RPQN O-RU in a restricted access location, and meet the minimum requirements of
RF exposure compliance distance.
2.2 Federal Communication Commission Interference
Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for help.
p
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
Version: v2.7
10
