Foundry FastIron SuperX, Руководство по установке оборудования

Страница: 126 / 198

FastIron Hardware Installation Guide for the FSX, FSX 800, and FSX 1600
7 - 12 © 2008 Foundry Networks, Inc. December 2008
EXAMPLE:
To enable the WAN PHY mode, enter commands such as the following:
FastIron(config)# link-config x10g wan-phy e 1/1 e 1/2
FastIron(config)# write memory
FastIron(config)# end
FastIron# reload
These commands change the PHY mode from LAN to WAN.
NOTE: The write memory and reload commands save the change to the startup-config file and place the WAN
PHY configuration in effect.
Syntax: link-config x10g wan-phy ethernet <slot-num/port-num>
where <slot-num/port-num> is a valid 10-Gigabit Ethernet port or ports.
Disabling and Re-enabling an Interface Module
NOTE: This section does not apply to the active management module. The disable module and enable
module commands are not applicable to the active management module. If you attempt to remove the
management module while the chassis is powered on and running, all traffic being handled by the system will
stop.
Before removing an interface module from the chassis while the chassis is powered on and running, disable the
module first. Disabling the module before removing it prevents a brief service interruption on other forwarding
modules. The brief interruption can be caused by the chassis re-initializing other modules in the chassis when
you remove an enabled module.
To disable a module, enter a command such as the following at the Privileged EXEC level of the CLI:
FastIron# disable module 3
This command disables the module in slot 3.
Syntax: disable module <slot-num>
The <slot-num> parameter specifies a valid slot number.
If you decide after disabling a module that you do not want to remove the module, re-enable the module using the
following command:
FastIron# enable module 3
Syntax: enable module <slot-num>
Installing or Replacing a POE Daughter Card
This section provides instructions for installing or replacing a Power Over Ethernet (POE) daughter card (part
number SX-24GCPOE) in the FastIron X Series chassis. The POE daughter card enables support for POE
power-consuming devices. The card is located in a connector slot on the 24-port Gigabit Ethernet copper
interface module.
You can install or replace a POE daughter card while the chassis is powered on and running. Before installing or
replacing the card, disable the module to prevent the remaining interface modules in the chassis from dropping
user packets.
NOTE: If applicable, install the POE (48V or 220V) power supply prior to installing the POE daughter card. The
system will not recognize the POE daughter card unless there is a POE power supply operating in the chassis.
See “Installing or Replacing a Power Supply” on page 7-17.