p-9
Cable and Wiring Information
Use high quality, shielded cables to connect your mixing console, workstation or other source to
your speakers. Foil-shielded cables should do quite well. Other high quality cables that incorporate
better shielding will yield an overall higher noise rejection, lowering your systems susceptibility to
external interference. Another important tip to keep in mind when wiring your system is to route all
line level cables away from the AC and other power sources, this will reduce the probability of hav-
ing AC hum emanating from your monitor system.
Product Cleaning Instruction
Prior to the cleaning the PM0.5d Personal Active Speaker System, the power must be turned off and
the AC cord is disconnected from the AC IN connector. Once the power has been terminated, clean-
ing can be accomplished using a dry cleaning rag. A light common household cleaner can also be
used, but care must be taken not to use harsh cleaning fluids. Regular dusting or cleaning with a dry
rag will keep your product looking new for years.
Amplifier maximum output
High frequency driver
23 W
Low frequency driver
35 W
Input
• Phone jack (TS) and RCA jack
Normal input level
-10 dBV
Input impedance
10 kΩ or more
• XLR Connector (Pin-1: GND, Pin-2: HOT, Pin-3: COLD)
Normal input level
+4 dBu
Input impedance
10 kΩ or more
Crossover Frequency
2 kHz
Power Consumption
Normal mode
60 W
Stand-by mode
0.5 W or less