12
STEP 1
-1A-
Cut the two plastic straps and the tape and open up the box
completely.
-1B-
Remove the polystyrene (
P
) and place it next to the box.
-1C-
Rotate the box completely so that the bottom of the hood rests on
the polystyrene (
P
).
-1D-
Unscrew the two screws (
Y
) and release the hood from the chip-
board panel (
T
).
-1E-
Unscrew the two screws (
Z
) that secure the upper pipe to the
inner frame. PLEASE NOTE: use your hands to hold the pipe and
slide it down.
STEP 2
-2A-
Check the required height from the ceiling to the bottom edge of
the hood, leaving 650/700 mm from the burner grids.
EN
CILINDRO ISLAND HOOD
ASSEMBLY INSTRUCTIONS
P
P
P
P
Y
T
Z
Z
650/ 700
Fig. 1
Fig. 2
