25
PROGRAMMABLE OPTIONS Cont.
22. MINIMUN STARTER CRANK TIME:
Default = 0.8 seconds
This option controls the Minimum Starter Cranking time. This does not affect maximum crank time. This can be
adjusted in 0.1 second increments Up or Down from 0.5 to 4 seconds. The starter can still crank up to 4 seconds
with a 0.8 setting, depending on Tach or Tachless setting.
TIMED START
, use Hybrid Mode (option 1-4) with this option to set a fixed crank time. Please Note: In Hybrid Mode
there is only 1 start attempt and the ignition is left on.
23. DIESEL GLOW PLUG DELAY
This option controls the system’s Diesel vehicle interface. Using this option you can control whether the unit
monitors the vehicle’s glow plug circuit using the Pink input wire (Default), or you may select a specific delay time
Before cranking. This option is helpful if you are unable to locate a glow plug signal. Just select a delay time and
do not connect the Pink Glow Plug wire. Selections: 10, 15, 20 seconds, or Monitor Pink Wire (Default).
24. REMOTE START ENGINE RUN TIME:
Set engine run time for 10, 20, 30 or 3 minutes as desired.
25. ULTRA-SMART TACHLESS VOLTAGE ADJUSTMENT:
This option controls the voltage reference point when using smart Tachless mode. Pressing the Lock or Trunk
buttons on the remote raises or lowers the reference level in 1% increments from 80%-%100. Button #2 resets the
unit to the factory default reference point of 93%. The default 93% setting works for most vehicles. See page 16 for
additional Ultra-Smart Tachless mode information.
26. IDLE DOWN RUN TIME:
This feature allows the remote starter to take over operation of a parked vehicle when the ignition key is removed
and you exit the vehicle. The vehicle will remain running for the programmed time or until canceled. There are 4
choices:
Default = 20 minutes.
1. 10 Minutes
2. 20 Minutes - Default
3. 30 Minutes
4. Infinity Run (parking lights flash in this mode)
