Fortinet Gate 60D, Руководство администратора

Страница: 40 / 706

Dynamically assigning VPN client IP addresses from a RADIUS record What’s new in FortiOS 4.0
FortiGate Version 4.0 Administration Guide
40 01-400-89802-20090424
http://docs.fortinet.com/ • Feedback
set type http
next
end
edit 2
set port 8008
set type http
next
end
edit 3
set port 4523
set type telnet
end
end
If your FortiGate unit is operating with virtual domains enabled, each VDOM has a
different non-standard authentication port configuration.
Dynamically assigning VPN client IP addresses from a RADIUS
record
SSL VPN tunnel mode, IPSec, and PPTP VPN sessions can now assign IP addresses to
remote users by getting the IP address to assign from a RADIUS record.
For more information, see Dynamically assigning VPN client IP addresses from a RADIUS
record .
DHCP over route-based IPSec VPNs
In previous releases of FortiOS, you could use DHCP to assign IP addresses to dialup
clients on policy-based IPSec VPNs only. In FortiOS 4.0, DHCP is also available to dialup
clients on route-based IPSec VPNs.
The configuration differs only slightly from that of a route-based dialup VPN with static IP
addresses.
1 Configure Phase 1 settings.
Remote Gateway must be set to Dialup User .
2 Configure Phase 2 settings.
Set Phase 1 to Dialup User .
In the Advanced Settings , select DHCP-IPsec .
For more information, see “DHCP-IPSec” on page 540 .
3 Configure a DHCP server on the virtual IPSec interface.
Set the server Type to DHCP . Enter the IP Range and Netmask that dialup clients will
use and the Default Gateway that dialup clients should use.
4 Configure an ACCEPT firewall policy with the virtual IPSec interface as source and the
local private network as destination.
SNMP upgraded to v3.0
SNMP v3.0 provides up-to-date information and status reporting about the hardware
running on your network.