Fortinet AP400 Series, Руководство по установке

Страница: 51 / 102

Where to Go From Here 37
AP433e LED Descriptions
Change LED Appearance
If you want to change the appearance of the LEDS, follow these steps:
1.
From the controller, click Configuration > Devices > AP , and then select the AP.
2.
Select one of these settings for the LED Mode setting:
• Normal: LEDs are as described above
•
Blink: Sets all LEDs flashing; this is useful to locate an AP
• Dark: Turns off all LEDs
3.
Click OK .
Where to Go From Here
Now that the AP433e is installed, refer to the Fortinet System Director Getting Started Guide
for instructions on initializing the hardware. Return to this chapter to check the status of the
LEDs once the WLAN is operational.
LED Function Troubleshooting
Power off—no power
green—presence of power
Status off—no power
green—booting stage 1
blinking green and off—booting stage 2
blinking green and white—discovering
the controller
blinking green and blue—downloading a
configuration from the controller
blinking blue and off—AP is online and
enabled, working state
blinking red and yellow—failure; consult
controller for alarm state
If the status LED is blinking red
and yellow, there is an alarm on
the AP. Determine what the
alarm is by clicking
Monitor >
Dashboard > Alarms and look-
ing at the AP alarms. You can
also use the CLI commands
show alarm and show log .