formlabs Form Cure L, Инструкция по установке и использованию

Страница: 16 / 40

14
Changes or modifications to this product not authorized by Formlabs could void the
electromagnetic compatibility (EMC) and wireless compliance and negate your authority to
operate the product.
This product has demonstrated EMC compliance under conditions that included the use of
compliant peripheral devices and shielded cables between system components. It is important
that you use compliant peripheral devices and shielded cables between system components to
reduce the possibility of causing interference to radios, televisions, and other electronic devices.
3.1.5 Isopropyl alcohol
Isopropyl alcohol is a flammable chemical. Keep away from ignition sources,
including open flames, sparks or concentrated sources of heat. Allow any printed
part cleaned with isopropyl alcohol to dry completely before post-curing.
Formlabs does not manufacture isopropyl alcohol. Consult the chemical manufacturer or
supplier for detailed safety information. Carefully follow the safety instructions provided with
the isopropyl alcohol that you purchase. Isopropyl alcohol can be flammable, even explosive,
and should be kept away from heat, fire, or sparks. Any containers holding isopropyl alcohol
should be kept closed or covered when not in use. We also recommend that you wear
protective gloves and have good ventilation when working with isopropyl alcohol.
3.1.6 Tripropylene glycol monomethyl ether (TPM)
Formlabs does not manufacture tripropylene glycol monomethyl ether. Consult the
chemical manufacturer or supplier for detailed safety information. Carefully follow
the safety instructions provided with the tripropylene glycol monomethyl ether you
purchase. We also recommend that you wear protective gloves when working with
tripropylene glycol monomethyl ether.
3.2 Personal protective equipment (PPE)
Safe operation of the Form Cure L can be achieved by using the following equipment:
• Non-reactive nitrile gloves
• Safety glasses
Resin and solvents may cause skin irritation or an allergic skin reaction. Wear
gloves when handling liquid resin, liquid solvent, or resin-coated surfaces. Wash
skin with plenty of soap and water.
Some methods of support removal may cause small pieces of supports to
break away. Beware of flying debris. Wear eye protection and gloves to
protect the skin and eyes.
DANGER
NOTICE
NOTICE
WARNING
CAUTION